Acquired LEGALLY these HD 12 gauge shotguns. Ran threw a few rounds of 000 in each. Very impressed with the quality.
Quote from: ArticSteve on October 08, 2020, 06:40:46 pmAcquired LEGALLY these HD 12 gauge shotguns. Ran threw a few rounds of 000 in each. Very impressed with the quality.Self protection or just a gun collector? Not for sport so just curious. Maybe for shits and giggles walking around blasting stuff?Went through a couple hundred 12 gauge rounds with some friends last weekend skeet shooting. What a blast.
Quote from: ArticSteve on October 08, 2020, 06:40:46 pmAcquired LEGALLY these HD 12 gauge shotguns. Ran threw a few rounds of 000 in each. Very impressed with the quality.Maverick brand?? Canuck brand??
Quote from: rrocket on October 08, 2020, 09:52:27 pmQuote from: ArticSteve on October 08, 2020, 06:40:46 pmAcquired LEGALLY these HD 12 gauge shotguns. Ran threw a few rounds of 000 in each. Very impressed with the quality.Maverick brand?? Canuck brand??Canuck .... Turkish Great value IMO.
Quote from: bridgecity on October 02, 2020, 12:54:49 pmQuote from: bridgecity on September 23, 2020, 01:30:21 pmDishwasher stopped washing yesterday (see things that irritate me thread). I started looking at Bosch dishwashers on the Costco website then decided I would dig into this one more. Pulled the washer last night, pulled the circulation pump and motor. Shaft from the pump into the motor sleeve was full of grit and the plastic sleeve is chewed up a bit. Cleaned it up, put it back together and its running again.I ordered a circulation pump/motor off amazon today for $150. Local parts store was $300. When it quits again I'll replace it and hopefully that takes care of it for a while. If not, its new dishwasher time.The dishwasher was acting up on and off all week. Motor/pump came a couple days ago so I installed it. So far so good with a couple of cycles run. And the saga continues. After a few cycles the dishwasher started leaking. Caught it soon enough that there’s only permanent damage to the hardwood where the washer sits, and it’s minor. Pulled it out to clean up the water, hooked it up outside of the cabinet to find the leak. It’s leaking from the rubber grommet that connects the pump to the sump. I must have damaged it when pulling it apart the last time. Anyway, there’s a Bosch in the dishwasher slot now. Found a store that actually had one in stock. I’ve ordered a new grommet and will replace it on the Kitchenaid when it comes. I’ll then sell the cursed unit with the new pump. I’m sure it’s all smooth running from here on out.
Quote from: bridgecity on September 23, 2020, 01:30:21 pmDishwasher stopped washing yesterday (see things that irritate me thread). I started looking at Bosch dishwashers on the Costco website then decided I would dig into this one more. Pulled the washer last night, pulled the circulation pump and motor. Shaft from the pump into the motor sleeve was full of grit and the plastic sleeve is chewed up a bit. Cleaned it up, put it back together and its running again.I ordered a circulation pump/motor off amazon today for $150. Local parts store was $300. When it quits again I'll replace it and hopefully that takes care of it for a while. If not, its new dishwasher time.The dishwasher was acting up on and off all week. Motor/pump came a couple days ago so I installed it. So far so good with a couple of cycles run.
Dishwasher stopped washing yesterday (see things that irritate me thread). I started looking at Bosch dishwashers on the Costco website then decided I would dig into this one more. Pulled the washer last night, pulled the circulation pump and motor. Shaft from the pump into the motor sleeve was full of grit and the plastic sleeve is chewed up a bit. Cleaned it up, put it back together and its running again.I ordered a circulation pump/motor off amazon today for $150. Local parts store was $300. When it quits again I'll replace it and hopefully that takes care of it for a while. If not, its new dishwasher time.
Quote from: bridgecity on October 07, 2020, 09:52:58 pmQuote from: bridgecity on October 02, 2020, 12:54:49 pmQuote from: bridgecity on September 23, 2020, 01:30:21 pmDishwasher stopped washing yesterday (see things that irritate me thread). I started looking at Bosch dishwashers on the Costco website then decided I would dig into this one more. Pulled the washer last night, pulled the circulation pump and motor. Shaft from the pump into the motor sleeve was full of grit and the plastic sleeve is chewed up a bit. Cleaned it up, put it back together and its running again.I ordered a circulation pump/motor off amazon today for $150. Local parts store was $300. When it quits again I'll replace it and hopefully that takes care of it for a while. If not, its new dishwasher time.The dishwasher was acting up on and off all week. Motor/pump came a couple days ago so I installed it. So far so good with a couple of cycles run. And the saga continues. After a few cycles the dishwasher started leaking. Caught it soon enough that there’s only permanent damage to the hardwood where the washer sits, and it’s minor. Pulled it out to clean up the water, hooked it up outside of the cabinet to find the leak. It’s leaking from the rubber grommet that connects the pump to the sump. I must have damaged it when pulling it apart the last time. Anyway, there’s a Bosch in the dishwasher slot now. Found a store that actually had one in stock. I’ve ordered a new grommet and will replace it on the Kitchenaid when it comes. I’ll then sell the cursed unit with the new pump. I’m sure it’s all smooth running from here on out.New grommet (seal) for dishwasher arrived a couple days ago. Was going to put it on and sell the unit but found out my nephew's dishwasher just kicked the bucket. I told him he could have this one. He's a good kid working towards his journeyman's for an industrial mechanic so if I can help him save a few bucks then why not. Hopefully it's all good for him. I told him I'd put the grommet in so its ready to go, he said "I'd rather do it myself than have an engineer do it". Ha ha, funny guy.
I would say smart guy not funny guy
I'm going to check / buy 4 Volt oem first generation mags tomorrow AM, as seen on FB Volt page. Lucky enough, it is close to me.They still have 4 original season tires on them, if i push mu luck, they would have working TPMS!
4 Volt gen 1 oem mags + tires with some remaining thread + tpms = $375, I'm a happy camper
Quote from: me_2 on October 25, 2020, 10:38:25 am4 Volt gen 1 oem mags + tires with some remaining thread + tpms = $375, I'm a happy camper Do the serial numbers start with 4B? If so they were made in Napanee where I used to work
Quote from: me_2 on October 25, 2020, 10:38:25 am4 Volt gen 1 oem mags + tires with some remaining thread + tpms = $375, I'm a happy camper I like this rim design. Not too heavy, not too flashy and very unique. Well done!
^^Holy Crap! That's a lot ambience! I hope your wine cellar is well stocked!Railton